1. Due to the low air pressure, thin air and low nutrient content in the plateau area, especially for the naturally aspirated diesel generator, the combustion conditions become worse due to insufficient air intake, so that the diesel generator can not issue the original specified rated power. Even though the diesel generators are basically the same, the rated power of each type of diesel generator is different, so their ability to work on the plateau is different.

考慮到在高原條件下著火延遲的傾向，為了柴油發電機的運行經濟性，一般推薦自然吸氣柴油機供油應適當提前。

Considering the tendency of ignition delay under plateau conditions, it is generally recommended that the oil supply of naturally aspirated diesel engine should be properly advanced for the operation economy of diesel generator.

由于海拔升高，動力性下降，排氣溫度上升，因此用戶在選用柴油發電機時也應該考慮柴油機的高原工作能力，嚴格避免超負荷運行。

As the altitude increases, the power decreases and the exhaust temperature increases, users should also consider the plateau working capacity of the diesel engine when selecting the diesel generator and strictly avoid overload operation.

根據近年來的實驗證明，對高原地區使用的柴油機，可采用廢氣渦輪增壓的方法作為高原的功率補償。通過廢氣渦輪增壓不但可彌補高原功率的不足，還可改善煙色、恢復動力性能和降低燃油消耗

According to the experimental results in recent years, the diesel engine used in plateau area can be compensated by exhaust gas turbocharging. It can not only reduce the fuel consumption and power consumption of the turbocharger, but also improve the power consumption of the turbocharger on the plateau

2、隨著海拔的升高，環境溫度亦比平原地區的要低，一般每升高1000M，環境溫度約要下降0.6攝氏度左右，外加因高原空氣稀薄，因此，柴油發電機的啟動性能要比平原地區差。用戶在使用時，應采取與低溫起動相應的輔助起動措施。

2. With the increase of altitude, the ambient temperature is also lower than that in plain areas. Generally, for every 1000m increase, the ambient temperature will drop by about 0.6 ℃. In addition, due to the thin plateau air, the starting performance of diesel generators is worse than that in plain areas. When using, the user shall take auxiliary starting measures corresponding to low-temperature starting.

3.、由于海拔的升高，水的沸點降低，同時冷卻空氣的風壓和冷卻空氣質量減少，以及每千瓦在單位時間內散熱量的增加，因此冷卻系統的散熱條件比平原差。一般在高原海拔地區不宜采用開式冷卻循環，可采用加壓的閉式冷卻系統以提高高原使用時冷卻液的沸點。

3. Due to the increase of altitude, the boiling point of water decreases, the wind pressure and cooling air quality of cooling air decrease, and the heat dissipation per kilowatt in unit time increases. Therefore, the heat dissipation condition of the cooling system is worse than that of the plain. Generally, it is not suitable to use open cooling cycle in plateau altitude areas. Pressurized closed cooling system can be used to improve the boiling point of coolant in plateau use.

以上就是今天帶給大家的知識發電機組專注行業多年，為用戶不斷的提供有價值的內容，更多內容請繼續關注我們：http://inyanfang.cn

The above is the knowledge brought to you today. The generator set has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://inyanfang.cn